ようやく納得できる仕上がりになった 結局二ヶ所のスイッチが必要になったが、OFFすることにより USBも今のところ問題なく使用できている(ONのままUSBに何か接続すると壊れるかもしれない) 配線は左ドングル、右Zero3es 1--スイッチ--1 +vcc 2--------2 -DATA 3--------3 +DATA 4--スイッチ--4 ID 4--------5 GND 結局、はじめにGNDで電源制御しようとしていたのが間違いだった Vccを接続した状態でDATA線のどちらか一つでも接続するとUSBがPCより認識できない 動作確認などで10回以上はバラシたんじゃないだろうか・・・ <注意事項> ※改造は自己責任で Pocket の手でレジスト変更するとパワーマネージメントが効かない(原因不明) 手動でTREなど使ってBluetooth・GPSを有効にする Zero3esの基盤右
リリース、障害情報などのサービスのお知らせ
最新の人気エントリーの配信
処理を実行中です
j次のブックマーク
k前のブックマーク
lあとで読む
eコメント一覧を開く
oページを開く